Discussion:
Power Designer 16.1 Error when running Check Model
(too old to reply)
n***@gmail.com
2013-09-30 18:56:39 UTC
Permalink
I am a new user to Power Designer, former ERWin user. I keep getting the following error in my PDM when Check Model runs:

Category Check
Physical Data Model Existence of Data Source Mapping

I cannot find where in Power Designer to change this setting. Currently I have no database serves to map for or connect to.
Sean S
2013-10-17 19:39:42 UTC
Permalink
Hi, Joseph. I'm not familiar with that particular error, but you're probably using a different DBMS than I am. However, if you hit F4 while you're in your physical model, you'll be presented with the Check Model Parameters dialog. Here, you can uncheck model checks that you'd prefer not to run. Expand the Physical Data Model group and you can uncheck the offending Check.

You can also change the properties of some checks (severity, auto-correction).

Sean
Post by n***@gmail.com
Category Check
Physical Data Model Existence of Data Source Mapping
I cannot find where in Power Designer to change this setting. Currently I have no database serves to map for or connect to.
Continue reading on narkive:
Loading...